Mid-Drive vs Hub Motor: What the Difference Actually Is
The motor position changes how a bike climbs, how it feels, what wears out, and what you can repair. In
our dataset of 258 priced models, the two designs separate cleanly on one number: torque per 100 W.
The one number that separates them
Divide torque by motor power and multiply by 100. Across 182 models where both figures are published, the median is
12.7 Nm/100W, with 60% below 14 and 24% above 18. The low group is
dominated by hub motors, the high group by mid-drives.
| Design | Typical Nm/100W | Where the motor sits |
|---|---|---|
| Hub (geared or direct) | 7–13 | in the wheel |
| Mid-drive | 18–40 | at the cranks |
How they behave
Climbing
A mid-drive turns the chain, so it can use the cassette’s low gears to multiply torque at the wheel. That is why a
250 W mid-drive can out-climb a 750 W hub motor on a steep grade. On flat ground the advantage mostly disappears.
Feel
Mid-drives usually pair with torque sensors and feel like an extension of your legs. Many hub bikes use cadence
sensors, which switch assist on and off rather than scaling it — a noticeable difference at low speed.
Wear and repair
Hub motors put no load through the drivetrain, so chains last longer. Mid-drives wear chains and cassettes faster, but
the motor itself is often easier to remove and service. A blown hub motor can mean a new wheel build.
Weight and handling
A hub motor adds weight at one end of the bike; a mid-drive keeps mass central. On a 30 kg cargo bike that difference
is small; on a 20 kg city bike it is noticeable when lifting.
Which to buy
- Flat commute, tight budget: hub. Simpler, cheaper, and the efficiency penalty is small at steady speed.
- Hills, cargo, or a natural pedal feel: mid-drive. The gearing advantage is real.
- Repairability in a small town: hub, because any shop can replace a wheel; mid-drive parts are brand-specific.
- High power (over 1,000 W): hub is common and cheaper, but check axle and torque-arm hardware.
How we measured it
We use published torque and nominal motor power. Where either is missing the model is excluded — 182 of the models
we track publish both. Values above roughly 40 Nm/100W are usually marketing figures or data errors rather than real
measurements, so treat the top of the range with suspicion.
What wears out, and what it costs
Hub motors put no load through the drivetrain: chains and cassettes last close to normal bicycle intervals. Mid-drives
push torque through the chain, so expect faster chain wear and, on powerful systems, more frequent cassette replacement.
Against that, mid-drive motors are usually easier to remove and service, and their controllers are often separate units
rather than potted into the hub.
Parts availability
Hub motors are close to commodity items: controllers, throttles and replacement wheels are widely available and cheap.
Mid-drive systems are brand-specific — a failed controller or torque sensor can mean a dealer part with a lead time. If
you live somewhere without a good e-bike shop, that difference can decide the purchase more than climbing performance.
FAQ
Is a mid-drive motor better than a hub motor?
It depends on the job. Mid-drives use the bike’s gears, so they climb better and feel more natural; hub motors are simpler, cheaper and easier to repair. For flat commuting a hub is often the better value.
How can I tell which one a bike has?
Look at where the motor sits: at the cranks (mid-drive) or in the wheel hub. In spec sheets, torque per 100 W is a useful signal — in our data 60% of models sit below 14 Nm/100W and 24% above 18.
Which is more reliable?
Hub motors have fewer moving parts and no drivetrain wear. Mid-drives put torque through the chain, so chains and cassettes wear faster — but they are easier to service on many bikes.